Shockwave for Erectile Dysfunction
More and more men are having shockwave therapy to fix their erectile dysfunction, either at a clinic or self-administered. This is a forum to for men to discuss what experiences they have had, what treatment they used, and what results they obtained. The goal is to get men to share their ideas, trials, successes and failures in order to help other men working to improve their mojo as well.
Index » Experiences with DIY shockwave » New issue after 2 months of use - starts out reading 200 degrees
Index » Experiences with DIY shockwave »
New issue after 2 months of use - starts out reading 200 degrees
More and more men are having shockwave therapy to fix their erectile dysfunction, either at a clinic or self-administered. This is a forum to for men to discuss what experiences they have had, what treatment they used, and what results they obtained. The goal is to get men to share their ideas, trials, successes and failures in order to help other men working to improve their mojo as well.
1 of 1
- WaltJ
- 2
Offline - Registered: 3/03/2022
- Posts: 3
New issue after 2 months of use - starts out reading 200 degrees
New issue after 2 months of use - starts out reading 200 degrees.
SW14
1. Turn On
2. Look at screen
3. reads 200 degrees celsius, which cannot be true.
4. Pops once and that is it. No more.
Ideas? What can I do? Take it apart?
- WaltJ
- 2
Offline
- Registered: 3/03/2022
- Posts: 3
Re: New issue after 2 months of use - starts out reading 200 degrees
Ok, since I have no options, I took apart what I could to find the faulty heat sensor ...
A) took off the fan cap and just see fan operating and glued in. Nothing to do there.
B) removed the two head screws, removed the aluminum tube, cap, and rod. All looks fine. Nothing to do there.
C) Removed the cover on the box to the 2 circuit boards. Looks new and good, no burnt or bulging capacitors, no dials knobs or adjustments.
- •
Thread Starter
1 of 1